Back to: Products

EcoMBR1 – ModBus relay

Switch loads by grid power or electricity price – with smart-meter connection and cloud

On request

  • Changeover relay (10 A, 250 V AC): switches by grid power (e.g. solar surplus), by the Tibber electricity price, by a “permanently on” switch on the device, or by hand
  • On and off thresholds freely adjustable, settings survive a restart
  • Reads a smart meter via ModBus RTU (RS485): voltage, current and power per phase, total power, grid frequency, total import and export
  • The meter is optional – without it only switching by grid power is unavailable
  • Current Tibber electricity price with price level, fetched by the sensor itself
  • Runs directly on 90–250 V AC, enclosure for DIN rail (TS 35)
  • Values in the ecosensors.cloud dashboard, firmware update at the push of a button
  • Tested with Chint DTSU 666 and Orno WE-516/517
  • Open hardware and software (ESPHome), enclosure for 3D printing

Variants

  • Chint DTSU 666Firmware dtsu666 Inquire
  • Orno WE-516/517Firmware we517 Inquire

There is no direct checkout: your inquiry reaches us through the contact form. Please briefly describe your site and purpose – the devices are equipped individually for it. We get back to you with a suitable quote (price, delivery time, shipping).

The EcoMBR1 uses its relay to switch a load – for example an immersion heater, a wallbox or a heat pump – exactly when it pays off: with solar surplus (by the grid power at the meter) or with cheap electricity (by the Tibber price). For the grid power it reads a smart meter through its ModBus RTU interface. All values go over WiFi to ecosensors.cloud and appear in your dashboard there.

You set the thresholds in the sensor’s web interface. Both controls can run at the same time, and a switch on the device keeps the relay on permanently if needed.

The explainer video shows the setup, the variants and the three controls (by hand, by electricity meter, by Tibber price) in just over two minutes.

Note: Only ModBus RTU (RS485) is supported, not ModBus TCP. The firmware has to match the meter – yours not listed? Get in touch. Connection and installation belong in the hands of a qualified electrician. Details, wiring diagram and enclosure for self-printing: EcoMBR1 documentation.

Technical data

WiFi802.11 b/g/n (2.4 GHz only)
Power supply90–250 V AC
Output1 changeover relay (NO/COM/NC), max. 10 A at 250 V AC
Data interfaceRS485
ProtocolModBus RTU, 9600 baud
ControllerESP32-WROOM-32E
Displaystatus LED
EnclosureDIN rail TS 35, 86 × 23 × 54 mm (H × W × D)
Supported serversEcoSensors
Open hardware / softwareyes / yes

Goes well with