EcoMBR1 - Commissioning
WiFi, registration and firmware update
The setup is the same for all sensors of the Eco series and is described in the general guide. Your sensor is called ecombr1-<ID>:
- Set up WiFi – connect to the hot spot
ecombr1-<ID>, enter the WiFi credentials - Open the web interface at
http://ecombr1-<ID>orhttp://ecombr1-<ID>.local - Set the access password – enter your own password in the Device Password field (user afterwards:
admin) - Register the sensor with the EcoSensor ID (
ecombr1-<ID>) and the Pairing Code from the web interface - Pair with Home Assistant – only if you use Home Assistant (switch Home Assistant API in the web interface)
If the web interface shows no meter values and Meter Status reads no response, check the wiring (A/B not swapped?) as well as baud rate, parity and ModBus address on the meter (see Configure the meter). You can also adjust the ModBus address the sensor queries in the sensor's web interface (entry Meter Modbus Address, group Meter).
Forgotten access password
If you have forgotten the access password, reset it on the sensor. The sensor is open again afterwards and you set a new password.
For this the housing has to be opened and the sensor has to be in operation: the board carries mains voltage. Have this done only by a qualified electrician.
- The sensor is running (it is not just starting up).
- Hold the IO0 button on the board (no. 4 in the figure under Connecting) pressed for 10 seconds.
- The password is then deleted: in the web interface Security reads "not protected" again and the red warning banner appears. The reset is noted in the sensor's log. Right after startup it can take a few seconds longer.
- Set a new password (Set the access password).
Never hold IO0 pressed while switching on or restarting: the sensor then does not start its firmware but waits for a flash operation. Release the button and restart the sensor.
Firmware update
The EcoMBR1 fetches updates itself from the internet:
| Way | Note for the EcoMBR1 | |
|---|---|---|
| A | Update via ecosensors.cloud | button Update now in the dashboard's Status widget |
| B | Update at the push of a button in the web interface | standard way: Firmware update button |
| C | Upload an update file | if the sensor has no internet; file from Firmware |
The sensor's version has the form product version+ESPHome version, for example 1.1.0+2026.10.2. The version of the EcoMBR1 comes first and rises with every update. After the + comes the version of ESPhome the firmware was built with. The web interface shows the installed version under Firmware and the latest one under Firmware Latest; if both match, the sensor is up to date. The sensor queries Firmware Latest every 6 hours; after a restart the field stays empty until then.
Always update to the variant that is already running on the sensor (see Variants). The general notes are under Firmware update.