Troubleshooting
LED messages and common problems
Find help here when a sensor does not behave as expected.
LED messages
Some sensors have status LEDs, of which usually the red one serves as the status LED. Normally the red LED does not light up at all.
- Red
- slow blinking: A warning is active. This is the case, for example, when reading a sensor value temporarily fails, when the WiFi or MQTT connection is interrupted (e.g. at startup) or when the Home Assistant interface is active but not connected.
- fast blinking: The sensor found an error during setup. In most cases it still tries to recover and carry on.
The hot spot does not appear
- After switching on, wait up to two minutes.
- The hot spot only appears if the sensor finds no known WiFi. If your old WiFi is still in range, it may keep connecting to it – switch it off briefly for the setup.
- Search for WiFis in the 2.4 GHz band; some smartphones hide networks without internet access or switch back to your home WiFi on their own. If necessary, temporarily disable mobile data and connect again.
I forgot the access password (EcoMBR1)
The password can only be reset on the sensor itself: Forgotten access password.
The web interface cannot be reached
- Are you connected to the same WiFi as the sensor (not the guest WiFi, not via mobile data)?
- If
http://eco…-<ID>does not work, tryhttp://eco…-<ID>.local, and if that does not work either, the IP address from your router (see Find the sensor). - Restart the sensor (disconnect and reconnect the power, or Restart in the web interface).
The sensor does not report to the dashboard
- Is the sensor registered?
- Does the web interface show the heartbeat green, but the sensor is offline in the dashboard? Check the internet access of your WiFi.
- If the Home Assistant variant runs without pairing, the sensor restarts every 15 minutes (see Home Assistant).
The firmware update does not work
- Way B: Does the sensor have internet access? If not, use Way C.
- Way C: Is it really the update file (
.ota.bin) and the variant that matches the sensor? - If the transfer breaks off, move closer to the sensor with your device or improve reception and try again.
- If none of this helps: Way D.